REAR CAMERA
The rear camera will be displayed automatically when vehicle is shifted into Reverse.
FRONT CAMERA
The front camera will display automatically when shifting the vehicle from Reverse into Neutral, or Drive. The front camera will be
displayed for 30 seconds, or until the vehicle is travelling at a speed of 7 mph. You can manually cancel / turn off the front camera
image by pressing the power button on the radio while it’s active.
To disable automatic front camera view when shifting from Reverse to Drive, follow these steps:
1. Place the car in Reverse
2. Press and hold the Power button for 5 seconds (the image of the rear camera may flash on the screen)
To enable automatic front camera view, repeat the steps above.
SIDE CAMERAS
The side cameras will be displayed automatically when you activate the turn signal (except in reverse).
MANUAL ACTIVATION OF CAMERA VIEWS
Press and hold the Power button for 2 seconds to access the rear camera then give a simple tap to toggle between front and rear
camera. To return to the radio screen press and hold the Power button for 2 seconds again.
Note:
During manual activation, the video display may flash momentarily when the vehicle reaches 7mph. This is normal operation.
Operation
In order to install the BCI-FD21 to another vehicle you must unlock the interface from the previous vehicle by turning off the video
input before removal.
Follow the steps below to turn off the video input:
• Turn the key to the Run position and keep it in Run position until the radio is fully “booted” and on a source screen.
• Set all the Camera Input Configuration dip switches to OFF.
• Disconnect and reconnect the BCI-FD21-H01 harness from the interface.
• Press and hold the Power button of the radio for 10 seconds.
• The LED will begin flashing RED and the radio will unprogram and restart in approximately 15 seconds.
• Once restarted, turn off the ignition, open the driver’s door and await until the radio is completely off (1-2 minutes).
• Turn on ignition, shift the vehicle into Reverse and verify no camera input screen is displayed. If radio source screen does not
change then you have successfully unprogrammed the radio and unlocked the interface from the vehicle. You can now install
the BCI-FD21 into another vehicle.
Installing the BCI-FD21 in Another Vehicle
Page 3
Rev. 071
9
16
PAC | Ph. 866-931-8021 | [email protected]
© 2016 AAMP Global
www.pac-audio.com
Camera Interface for Select Ford & Lincoln Vehicles with
MyFord Touch or MyLincoln Touch 8.4” Radios
BCI-FD21
