Installation of bathtub
When place for tub is prepared, water and drainage assembled, bathtub is ready for installation.
Fix the longest bathtub side to the wall.
Adjust the height of the tub using unit feet (drawing a); loosen the nut C, adjust the right height of the feet D. Fix
the feet D and fasten the nut C.
The distance between front panel and the floor has to be less than 20 mm.
Installation of bathtub panels
Use springs and angles for panels’ fixation to the tub (drawing b). Front panel has to be set first.
The lower edge of the panel fasten with springs (position C2) to the frame and upper edge put between angles
and tub’s body (position C1). Using 2 screws fasten side panel to the front panel (position C3).
Instruction for bathtub and whirlpool using
Clean the tub after using with soft cloth, in case of necessity use sanitary cleaning liquid (such as Cillit, Ajax).
Avoid abrasive, acid and alkaline cleaners!
Avoid the contact with hot objects (such as cigarettes, hairdryer, all kind of candles and others with temperature
more than +85
o
C) and open flame with the bathtub’s surface.
Avoid durable contact of the following substances with the tub’s surface:
Silicone oils, spirits (over 30%), all-purpose adhesives, sprayers, inapplicable sanitary cleaners and disinfectants,
hydrogen peroxide, pesticides dissolved in water, derv, acrylic paints and varnishes, acetic acid up to 25%,
other active chemical substances.
Exclude the tub’s surface contact with the following substances:
Sealing compounds on acrylic and polyurethane base, camphor, nail varnish and remover of nail varnish,
foam plastic, PVC and rubber in plastic condition, concentrated methyl alcohol, stain removers, iodine tincture,
gasoline, solvents, nitrocellulose varnish, concentrated acetic acid, acetone, liquid ammonia, chlorine, ether
high acids.
For more detailed information contact manufacturer PAA.
Avoid mechanical damages of unit – hard impacts and scratches.
Do cleaning of massage system pipes with professional liquids not less than once in 2-3 months.
First fill up the tub with the cold water and only then with hot one.
In case water mixer is leaking or damaged, fix or change it immediately.
Warranties
All PAA products are provided 2 years warranty.
Warranty for PAA bathtubs’ surface is 5 years.
All massage tubs, installed by PAA certified specialists, are provided 3 years warranty.
Warranty requirements
The warranty shall not apply to:
damage caused by incorrect transportation or inadequate packing during shipment
damage caused by failure to adhere to any of the operating, installation or maintenance instructions stated in
our manual
any incorrect operating procedures in bathtub or whirlpool, breakage or damages caused by the fault, care-
lessness, misuse, improper maintenance, abuse or modification of the product, as well as any chemical or
natural corrosion, fire or any other causality
damages caused by using in conditions which the bathtub is not provided for.
PAA reserves the right to discontinue or change models, colours and design specifications without
prior notice and without incurring of any obligations.
