P800 Solar Eclipse, Руководство пользователя

Страница: 14 / 44

14
3 INSTALLATION
During installation and start up of Solar Eclipse, always refer to the guidelines and the safety instruction.
See Chapter 2 of this manual.
3.1 Unpacking
Apart from the
Solar Eclipse, the box includes the following:
•
n. 1 bracket;
•
n. 1 grid power sensor;
•
n. 2 grid power sensor connectors;
•
n. 7 PG-9 clamp;
•
n. 1 16 mm cap;
•
n. 4 MC4 type solar connectors;
•
n. 6 ring lug;
•
n. 6 ring lug M6 screws;
•
n. 1 ExtremeSpeed 6x32 mm 10 A FF spare fuse
Figure 3 – Accessories included
After unpacking the product, check for any damage. Do not use the product if it is damaged. In case of
doubt, contact your supplier.
3.2
Environment
During installation follow below instructions:
•
Solar Eclipse is only suitable for indoor use
•
Ambient temperature: -10 - 40° C.
•
Humidity, non condensing: 0-95%.
•
Mount the Solar Eclipse vertically on a stable surface, with the cables facing down.
•
Ensure the hot air produced during operation discharge. The Solar Eclipse should be
mounted in such a way as not to prevent the blocking of the air flow through the ventilation
holes.
•
Do not place any objects within a distance of 15 cm 25 cm laterally and vertically with
respect to Solar Eclipse.
•
Do not place the Solar Eclipse in the same place with liquid electrolytes batteries.
•
Do not install Solar Eclipse immediately above liquid electrolyte batteries, due to the risk of
corrosive vapors and explosives, in case these are to.
Figure 3 - Included accessories