P3 International P7880, Руководство по эксплуатации

Страница: 5 / 8

sET uP
HoW To cLEan
Position the LED Bug Trap on a flat, stable surface where a power
source is easily accessible. Plug the adapter in and set the switch
ON/OFF (located on the back of the LED Bug Trap).
To maximize the effectiveness of the LED Bug Trap, it is important to
install the unit in the best location. In general, dark places are ideal,
taking care to make sure the UV lights are not obstructed. Because
insects are attracted to these lights, if they cannot see them, the unit
will not be fully effective. Try to avoid placing the unit too close to other
light sources as this may reduce its effectiveness.
As the unit traps insects, their remains will be collected in the net inside
the LED Bug Trap. To clean the unit, make sure the device is turned off
and disconnected from the outlet.
To empty the net, remove it by inserting your fingers in the openings
on the back of the unit and twisting it in a clockwise motion as shown
in figure 1 . Remove the net by gently removing it from the housing as
shown in figure 2 .
After the net has been removed, dispose of the collected insects and
make sure the mesh is clean and unobstructed. Once clean, reinsert
the trapping net and secure it by turning it counter-clockwise.
The time between each cleaning will vary depending on your insect
population so check your unit on a weekly basis and clean insect
remains to maintain optimal effectiveness of the device.