P1PE P4200PWT, Руководство пользователя

Страница: 17 / 24

19
MAINTENANCE
Checking Spark Plug
• Disconnect the spark plug wire from the spark plug.
• Before removing the spark plug, clean the area around its base to prevent debris from entering the engine.
• Clean carbon deposits off the electrode with a wire brush.
• Check the electrode gap and slowly adjust to 0.80mm (0.031in.) if necessary.
• Reinstall spark plug and tighten to Torque 22.0 – 26.9 Nm (16-20 ft-lb).
• Reconnect spark plug wire.
• If spark plug is worn replace only with an equivalent replacement part. Spark plug should be replaced annually.
Repairing Leaking Connections
• Purchase O-Ring / Maintenance kits through the Authorized Dealer and follow instructions provided with kit.
Air Filter
•
•
•
•
Storing Pressure Washer
If storing pressure washer for 30 days or more follow the procedures below:
• Add fuel stabilizer to unleaded petrol to keep the petrol from going stale and to prevent gum deposits from
forming on the carburetor. Run engine for a couple of minutes to circulate the fuel stabilizer.
•
• Disconnect the spark plug wire and clean the spark plug. Leave spark plug wire disconnected.
•
• Cover unit with a suitable protective cover to keep unit dry.
• Store unit in a frost-free area.
• Never attempt to repair high pressure hose, always replace.
• Never attempt to repair leaks with sealant, always replace O-ring or seal.
Water pressure produced by this unit can cut through skin and tissue leading to serious
injury and possible amputation.
WARNING!
WARNING!
.
.