P.S.I TireView, Руководство по установке и обслуживанию, Страница: 23 / 35

Section 1 - TireView
™
TPMS Instruction Manual
Low Pressure Alarm 100 PSI (6.9 BAR)
Displayed Temperature Units °F
High Temperature Alarm 158 °F (70 °C)
Setting the Displayed Pressure Units
1. Press and hold the SET button until a beep is heard from the display.
2. Press the + button three times. SET will show at the bottom of the display and BAR/PSI will be blinking.
See
Figure 10
.
Figure 10: Pressure Units Screen
3. Press the SET button again.
4. Press the + button to select PSI or BAR .
5. Press the SET button again to save the selection.
6. Press the BACK button to return to the main screen.
Setting the Low Pressure Alarm
Note:
If the tire pressure is below the default low pressure setting of 100 PSI (6.9 BAR), set the low pressure alarm
setting the high pressure alarm. The high pressure alarm cannot be set below the low pressure alarm value.
1. Press and hold the SET button until a beep is heard from the display.
2. Press the + button one time. LO PRESSURE SET will show on the display. See Figure 11 .
Figure 11: Low Pressure Set Screen
3. Press the SET button to enter that mode.
4.
Press the
GO
button to scroll/cycle to a specific axle.
5. Press the + button or the - button to adjust the low pressure alarm to 10% below the normal tire pressure
for that axle. See
Figure 12
.
© Pressure Systems International Inc.
All rights reserved worldwide.
23 T004-01 Rev 06-19