Section 1 - TireView
™
TPMS Instruction Manual
When selecting a trailer on the TireView
™
TPMS display:
1.
Make sure to adjust the high pressure and low pressure alarms for each trailer that has sensors paired to it.
On the main screen:
1.
Press the
GO
button to scroll/cycle and view the trailers that have sensors installed on them.
2.
Press the
SET
button until the display beeps and then release it.
3.
Press the
+
button nine times until
SET ID TRAILER
shows on the TPMS display.
4.
Press the
SET
button to enter that mode.
5.
Press the
GO
button to scroll/cycle to the desired trailer (1-4).
6.
Press the
SET
button again. The first digit will blink.
7.
Press the
GO
button to go to the first digit on the trailer section on the TPMS display.
8.
Press the
+
button or the
-
button to select the value of the first digit.
9.
Press the
GO
button to go to the next digit.
10.
Do steps 7-8 again for the second and third digits.
11.
Press the
SET
button to save the three-digit trailer ID.
12.
Press the
GO
button to scroll/cycle to the next trailer.
13.
Do steps 5-10 again to set the three-digit trailer ID for the remaining trailers.
14.
Press the
BACK
button two times to return to the main screen.
Programming Sensor Codes into the Display
Note:
Keep all sensors at least three feet away from the sensor being paired.
Note:
Sensors will begin reading as soon as they are coded into the display. When returning to the main screen by
pushing the
BACK
button twice, you may hear an alarm and see a pressure reading of “0”. This is normal. Once the
high/low settings are in place and set up is complete, these alarms will not sound. Simply push any button quickly to
silence the alarm.
Note:
It is recommended to label each sensor first with the provided tire position stickers, similar to the following
.
Figure 4: Tire Sensor Position Pattern
Automatic Code Learning (option #1)
Note:
Code all of the sensors to the display BEFORE screwing them onto the tire valve stem, unless otherwise
noted.
1.
Push and hold the
SET
button until it beeps. The
HI PRESSURE SET
parameter will blink at the bottom of
the screen. Push the
+
button and scroll through the parameters until
LEARN ID
appears.
2.
Quickly push and release the
SET
button. The first tire on the display will blink. If programming a different
tire, press the
+
button to move to the correct tire. Push the
SET
button again and
FFF FFF
will flash. Touch
the desired sensor for that tire position to the bottom of the display and then push the
GO
button. See
.
© Pressure Systems International Inc.
All rights reserved worldwide.
17
T004-01 Rev 06-19
Содержание TireView
Страница 2: ......
Страница 5: ...Table of Contents Pressure Systems International Inc All rights reserved worldwide 5 T004 01 Rev 06 19...
Страница 6: ...Pressure Systems International Inc All rights reserved worldwide 6 T004 01 Rev 06 19...
Страница 8: ...Pressure Systems International Inc All rights reserved worldwide 8 T004 01 Rev 06 19...