Changing the cylinder:
Turn off the regulator and disconnect the regulator from cylinder, allow the heater to control fully before removing
and replace the cylinder. Do not attempt to remove the regulator while the heater is still running.
Change LPG cylinder in ample ventilated area, and from any ignition source (candle, cigarettes and so on).
Maintenance:
●When the heater is not in use of a period of time, for instance, over the summer, we recommend that it is kept
covered or replaced in its carton to minimize the accumulation of dust dirt that may occur.
●Maintenance and cleaning must be carried out with the gas supply turned off and the heater cold. Do not attempt
to clean the heater while it is in use.
●Your heater should be checked annually by a qualified person for safe operation and to detect any faults.
●If any faults are detected in use, stop using the heater and contact your dealer for advice.
●Periodically clean the exterior and rear cylinder, storage area of your heater to remove dust a lint built-up, which
may affect operation of the heater.
●Light vacuuming with a soft brush will remove any dust built-up on the surfaces of the ceramic elements. Do not
scrape of knock these elements as they may become very fragile with use.
●Do not abrasive products to clean the heater.
●Watch the pilot flame while it is in operation. It should burn steadily, if it flickers or is yellow tipped, the heater
should be checked for correct operation.
●If any parts need replacement, they must be replaced only with genuine original parts supplied by the manufacturer.
The use of incorrect or substitute the parts may be dangerous and will void any warranty.
Do not use wet rag or sprinkling water on the heater while cleaning. This may cause serious problem to the heater.
Under the circumstance of normal usage, contact our agents to conduct regulator maintenance.
Leave the heater at a clean and dry area when it is not used.
Operate the heater according to following procedures when electric power is used.
The electric heating system is designed with technology of infrared radiation. Even if it is used in an unsealed and
large size room., heating efficiency will be perfect. Choose different control level for your various demands.
2)
Operation
f.
Make sure plug is normally earthed. Put plug in the socket.
g.
Press switch- to start the top quartz tube.
h.
Press switch- to start the other two quartz tubes.
i.
Press switch- to start all quartz tubes. Heat load reaches to peak.
j.
Turn all switch off after use. Remove the plug from the socket.
As shown in following Figure.