www.pmlighting.com
READ THESE INSTRUCTIONS ENTIRELY BEFORE BEGINNING INSTALLATION!
Congratulations on your decision to purchase one of the finest quality LED landscape lighting systems on the
market today. When properly installed and maintained, this system will provide years of trouble free service
and allow you to illuminate your home like a professional. Just follow these easy steps to design and install
the CS8100 system and any add-ons or upgrades you may have purchased. For additional help and
information on installing your system, visit our web site a
WHAT’S INCLUDED:
4 each CS937-LED Copper Bullet/Spot Lights
100 feet Landscape Cable 14/2 gauge
4 each CS936-LED Copper Area/Path Lights
1 each Outdoor Timer with Photocell
1 each CS100T Pro-Series Transformer
1 each Stake Driver Cap (Installation Tool)
TOOLS REQUIRED/RECOMMENDED FOR INSTALLATION:
Screwdriver (Flat & Phillips Head)
Shovel
Wire Cutter
Hammer
Wire Stripper
100-Ft Measuring Tape
Pliers
Power Drill and Bits (3/16” bit for plastic anchors)
Dead Blow Mallet (for stake installation)
Gloves
BASIC SYSTEM DESIGN STEPS:
LED landscape lighting
is quite easy to install and is much easier than traditional halogen systems.
LED lighting allows the running of cables with less complications of the dreaded “voltage drop” that
occurs more readily with halogen systems and other higher wattage incandescent systems. Just
follow these four easy steps for a successful installation.
A.
Determine the location of the power transformer before installation
and make sure a suitable 115/120VAC
covered GFCI outlet marked “WET LOCATION” is within reach of the transformer power cord. Attach and
secure transformer to the wall a minimum of 12 inches above ground using screws and anchors (if needed).
Mounting screws are provided for your convenience.
B.
Lay out the 14/2 gauge MAIN SUPPLY CABLE according to the
Easy Design Guide
on the next page, paying
close attention to where your fixtures are located and distances to determine the length of cable needed.
C.
Install each luminaire according to the individual instruction sheets, attach each luminaire to
the Main
Supply Cable using the attached easy connectors
, and bury loose cable as desired (6 inches deep or less).
D.
Plug
Power Transformer
into the
Timer with Photocell
, plug the timer into the GFCI outlet, and turn the
Timer dial to the desired setting for Dusk/Dawn, or Dusk On/ Off in 2, 4, 6, or 8 hours.
CS8100 Professional
Series
LED Landscape Lighting System
–
pg. 1
