www.EasyAssemblyRequired.com
To clarify installation and wiring of your 300 watt (or 600 watt transformer if purchasing the CS960T
Upgrade), please refer to the instructions below.
1) USE ONLY THE BOTTOM SCREW TERMINALS TO ATTACH THE MAIN CABLES FROM THE LIGHT FIXTURE
RUNS.
DO NOT LOOSEN TOP SCREWS OR REMOVE WIRES ATTACHED TO THE TOP SCREWS
.
2) FOR THE 600 WATT TRANSFORMER, TERMINALS 1 AND 2 ARE USED FOR THE FIRST 300 WATTS OF
POWER AND TERMINALS 3 AND 4 ARE USED FOR THE SECOND 300 WATTS OF POWER.
EACH MAIN
CABLE RUN MUST BE CONNECTED TO EITHER 1 AND 2 OR 3 AND 4.
SEE DIAGRAM BELOW (SHOWING UP
TO 4 MAIN CABLE RUNS).
3) ATTACH ONE SIDE OF THE MAIN CABLE RUN TO THE LEFT TERMINAL (1 OR 3 IF INSTALLING THE 600
WATT TRANSFORMER) BY INSERTING THE STRIPPED WIRE (APPROX. ¾”) INTO THE BOTTOM OF THE
TERMINAL BLOCK. ATTACH THE OTHER SIDE OF THE MAIN CABLE RUN TO THE RIGHT TERMINAL (2 OR 4
IF INSTALLING THE 600 WATT TRANSFORMER). TIGHTEN BOTTOM TERMINAL SCREWS TO SECURE EACH
WIRE.
CS9300 Professional
Series
Supplemental Wiring Instructions
300 Watt Transformer
600 Watt Transformer
Insert one side of each main cable run into the bottom of the terminal block
in the LEFT screw terminal and one side in the RIGHT screw terminal.
DO NOT LOOSEN TOP SCREWS OR
REMOVE ANY WIRES IN TOP
PORTION OF TERMINAL BLOCK!
L
R
L R
L R
Circuit #1
Circuit #2