9
MAN 9063197 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70212626
6600-Vejen, Denmark
E-mail: [email protected]
Setting up
1.
Localise the high-pressure outlet hose on the high-pressure cleaner and ensure that it
is securely connected to the vehicle undercarriage cleaner’s outlet. Connect the other
end of the high-pressure hose to the pistol on the vehicle undercarriage cleaner.
2.
Connect one end of the water supply hose to the vehicle undercarriage cleaner and
the other end to the high-pressure cleaner.
Preparing the surface
1.
Remove all loose material from the area that is to be cleaned.
2.
Never attempt to clean areas that have protruding items. If the equipment comes into
contact with obstacles, it may damage the equipment. Should the equipment come
into contact and the machine consequently vibrates when operated,
stop
the work
and replace the rotary arm.
CAUTION
Risk of damaging the machine!!
Never use the equipment if it starts to vibrate! Switch off the machine and
tighten the rotary arm, bolts and joints.
Inspect the machine before starting
1.
Before use, inspect the vehicle undercarriage cleaner. Tighten the rotary arm, bolts
and joints as required.
2.
Ensure that all joints are tightened securely. Set the water supply to ON (but do not
start the vehicle undercarriage cleaner!).
3.
Check to ensure that the hoses are free of kinks, fissures or leaks. If any faults are
detected,
then do not use the hose!
Replace the hose before starting.
Coupling
Snap coupling
