4
MAN 9050827 EN V4
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70 21 26 26
DK-6600 Vejen
e-mail: [email protected]
Instructions for Use
1.
Before using the equipment, inspect all the tank components carefully and make sure
that all the valves are in the OFF position.
2.
Loosen all the mounting nuts and open the lid, fill the tank with the correct amount of
paint and adjust the viscosity to the desired level (do not fill the tank to more than ¾
capacity to ensure smooth operation). Replace the lid and secure it with the mounting
nuts – make sure it sits properly and the tank is not leaking.
3.
Connect the compressed air source to the air inlet on the spray paint tank via the
oil/water separator. Adjust the pressure setting to an operating pressure of 2–3 bar (do
not exceed 4 bar/58 psi).
4.
Set the switch to the ON position and open the air source to the self-priming pump.
Start the pump to fully mix the paint in the tank.
5.
Connect the paint hose (with the spray gun) to the paint tank. Open the outlet valve
and start to paint.
6.
When the tank runs out, disconnect the air source and turn the pressure relief valve to
shut off the compressed air. Open the lid and fill with new paint. Repeat steps 2–4.
Maintenance
1.
When the tank is empty, disconnect the air source and turn the pressure relief valve to
shut off the compressed air. Remove the lid and pour out any remaining paint.
2.
Fill the tank with water or a suitable solvent and spray until the tank is clean. If paint is
left in the spray gun or hose, this will clog the equipment when it dries. After cleaning,
replace the lid and secure it with the nuts. Turn all the valves to the OFF position.
We retain the right to change the technical parameters and specifications of this product without prior notification.
