2
MON 9042831 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: 70212626
DK-6600 Vejen
e-mail: [email protected]
1.
Assemble the sides of the firewood shelter. Start with two side panels and
assemble them with connectors at the bottom and top. Note that there is
only one type of connectors. Continue until you have assembled an
octagon (8 joints with 1 section connector at the bottom and 1 section
connector at the top - a total of 16 section connectors must be attached.
2.
Insert the roof support arms into the roof support as shown in the first photo. Then insert the roof
support arms into the top section connectors as shown in the second photo. It is easiest if the roof
support arms are inserted alternately opposite each other, so that the octagon is divided in half first.
Continue to insert the roof support arms in this way.
3.
Lay the roof tarpaulin over the roof support arms and screw the rood support topper down onto the
roof support.
4.
Use the elastic ball ties to secure the roof to the side panels. Thread the elastic through a hole in the
roof tarpaulin and wrap it around the bars of two adjacent side panels and pull it through the hole so
that the elastic comes back to the front of the roof tarpaulin, then fasten it around the ball of the
elastic.
5.
The firewood shelter is now ready for use.
Note that it is recommended to secure the firewood shelter to the
ground for better stability, especially in bad weather.
We reserve the right to change the technical parameters and specifications of this product without prior notice.