5
MAN 9035966 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70212626
6600 Vejen, Denmark
E-mail: [email protected]
Safety instructions
General safety instructions
•
Read the user manual thoroughly before using the equipment.
•
Observe all safety instructions.
•
Always save the user manual for future use.
•
Ensure that the user manual accompanies the machine if it is loaned or sold again.
•
The equipment may only be used if in safe and good working order and must be taken
out of service immediately in the event of a fault.
•
Never use the equipment where there is an explosion hazard or in the vicinity of
flammable fluids or vapours.
•
Make sure the equipment is properly switched off and cannot start accidentally.
•
Do not use the equipment, if the ON/OFF switch does not function properly.
•
Keep children at a safe distance from the equipment. Always store the equipment out
of the reach of children and unauthorised persons.
•
Do not overload the equipment and use it only as intended.
•
Exercise caution and do not use the equipment if you are tired or have consumed
alcohol, drugs or medicine.
•
The equipment is not intended to be used by persons with reduced physical, sensory
or mental function or who lack experience with and/or knowledge about the
equipment unless they are supervised or have been instructed by a person who is
responsible for their safety.
•
Always comply with applicable local and international legislation relating to health,
safety and the working environment.
Electricity
•
The equipment may only be connected to a power outlet that is correctly installed and
which has an earth connection.
•
The fuse must be a residual current device tripped at max. 30 mA.
•
Ensure that the power supply complies with the specifications for the equipment
before connecting it.
•
The equipment may only be used within the specified areas of voltage and power (see
type plate).
•
Do not touch the plug with wet hands. Always remove the plug from the socket by
pulling the plug and not the cable.
•
Protect the cable. Do not bend it or drive over it and protect it from sharp edges, oil
and heat.