Decorative Glueboard Insect Control
C
2008
P+L Systems Ltd
Information provided on these instructions is modified and
updated from time to time. This is due to the constant
redevelopment of our products. As such, it is not intended that
you should rely on it or that it should form part of any contract.
P+L Systems Ltd
Ten St James Business Park
Grimbald Crag Court
Knaresborough
HG5 8QB UK
T +44 (0)800 988 5359
F +44 (0)1423 863 497
W www.pandlsystems.com
E [email protected]
Starter Replacement
Tube Replacement (Professional)
SPECIFICATION / REPLACEMENT PARTS
GLUEBOARD REPLACEMENT
BEFORE REPLACING THE GLUEBOARD, ALWAYS ENSURE THAT THE UNIT IS DISCONNECTED FROM THE
MAINS SUPPLY.
The glueboard should be replaced every month with a genuine glupac
™
glueboard. Use of
non-approved glueboards may invalidate your guarantee.
To replace the glueboard…
1. Swing open the front guard by first lifting it up, then pulling forward.
2. Remove the used glupac
™
glueboard by simply sliding it out from the top of the unit
and either retain for catch evaluation or dispose of it hygienically.
3. Remove the protective release paper from the new glupac
™
glueboard.
4. Slowly slide the new glupac
™
glueboard into position with the adhesive side facing
the tubes.
5. Replace the front guard by reversing the first step.
Always ensure the selected genuine glupac
™
glueboards are compatible with your unit,
available from your PCO or P+L Systems Ltd.
TUBE REPLACEMENT
BEFORE REPLACING THE TUBES, ALWAYS ENSURE THAT THE UNIT IS DISCONNECTED FROM THE MAINS
SUPPLY.
To ensure the efficiency of
Luralite Plus
TM
in catching flying insects, the UV tubes should be
replaced annually. After twelve months the phosphor coating that emits the correct wavelength
of UV light has burnt away and the UV output is diminished substantially.
To replace the UV tubes…
Luralite Plus
1. Rotate the tube through 90 degrees.
2. Gently pull the tube away from the unit.
3. Reverse the process with the replacement tube.
STARTER REPLACEMENT
BEFORE REPLACING THE STARTERS, ALWAYS ENSURE THAT THE UNIT IS DISCONNECTED FROM THE
MAINS SUPPLY.
The starters provides an extra spark to initially light the UV tubes. Starters wear out and should be
replaced at the same intervals as the UV tubes.
To replace the starters…
1. Swing open the front guard by first lifting it up, then pulling forward.
2. Rotate the starter anti-clockwise.
3. Pull the starter free from the unit.
4. Replace the front guard by reversing the first step.
R2 05/08
Unit
Luralite Plus
Voltage
230V ~ 50Hz
Dimensions(mm)
625 x 220 x 155
Coverage
50 Sq. Metres
Weight
2.5
Kg
Light Output
30W
Tubes
2
x
I616
Starter
2
x
I154
Glueboards (x6)
INL199
Wall Fixing points
380mm
