Tube Replacement
Starter Replacement
SPECIFICATION / REPLACEMENT PARTS
Unit
FTP30
Voltage
230V ~ 50Hz
Dimensions(mm)
470 x 305 x 152
Coverage
80 Sq. Meters
Weight
4 Kg
Light Output
30W
Tubes
2 x I616
Starter
2 x I154
Glueboards (x6)
INF196
Unit
FTP40
Voltage
230V ~ 50Hz
Dimensions(mm)
610 x 305 x 152
Coverage
120 Sq. Meters
Weight
5 Kg
Light Output
40W
Tubes
2 x I618
Starter
2 x I154
Glueboards (x6)
INF198
Unit
FTP80
Voltage
230V ~ 50Hz
Dimensions(mm)
610 x 305 x 152
Coverage
240 Sq. Meters
Weight
5 Kg
Light Output
80W
Tubes
2 x I662
Starter
2 x I154
Glueboards (x6)
INF198
GLUEBOARD REPLACEMENT
BEFORE REPLACING THE GLUEBOARD, ALWAYS ENSURE THAT THE UNIT IS
DISCONNECTED FROM THE MAINS SUPPLY.
The glueboard should be replaced every month with a genuine glupac™
glueboard. Use of non-approved glueboards may invalidate your guarantee.
To replace the glueboard…
1. Remove the used glupac™ glueboard by simply lifting it clear from the
unit and either retain for catch evaluation or dispose of it hygienically.
2. Remove the protective release paper from the new glupac™ glueboard.
3. Slowly slide the new glupac™ glueboard into position along the two
runners with the adhesive side facing the tubes.
Always ensure the selected genuine glupac™ glueboards are compatible with your
unit, available from your PCO or P+L Systems Ltd.
TUBE REPLACEMENT
BEFORE REPLACING THE TUBES, ALWAYS ENSURE THAT THE UNIT IS DISCONNECTED
FROM THE MAINS SUPPLY.
To ensure the efficiency of
Flytrap Professional
TM
in catching flying insects, the UV
tubes should be replaced annually. After twelve months the phosphor coating that
emits the correct wavelength of UV light has burnt away and the UV output is
diminished substantially.
To replace the UV tubes…
1. Rotate the tube through 90°, freeing it from the tube holders.
2. Pull the tube away from the chassis.
3. Dispose of the used UV tube in conjunction with local WEEE regulations.
STARTER REPLACEMENT
BEFORE REPLACING THE STARTERS, ALWAYS ENSURE THAT THE UNIT IS DISCONNECTED
FROM THE MAINS SUPPLY.
The starters provide an extra spark to initially light the UV tube. Starters wear out and
should be replaced at the same intervals as the UV tubes.
To replace the starters…
1. Rotate the starter anti-clockwise.
2. Pull the starter free from the unit.
Glueboard Replacement
WEEE Compliance No. 01576542
C
2009
P+L Systems Ltd
Information provided on these instructions is modified and
updated from time to time. This is due to the constant
redevelopment of our products. As such, it is not intended that
you should rely on it or that it should form part of any contract.
P+L Systems Ltd
Ten St James Business Park
Grimbald Crag Court
Knaresborough
HG5 8QB UK
T +44 (0)800 988 5359
F +44 (0)1423 863 497
W www.pandlsystems.com
E [email protected]
R3 02/09
