P.I.T. PSB20H-10B, Руководство пользователя

Страница: 8 / 25

Cordless Impact Drill
7
Removing the battery
The battery is equipped with two locking lev-
els that should prevent the battery from falling
out when pushing the battery unlocking but-
ton unintentionally. As long as the battery is
inserted in the power tool, it is held in position
by means of a spring.
To remove the battery, press the unlocking To
remove the battery , press the unlocking but-
ton and pull out the battery toward the front.
Do not exert any force.
Changing the Tool (see fi gure A)
► Before any work on the machine itself
(e. g. maintenance, tool change, etc.) as
well as during transport and storage,
remove the battery from the power tool.
There is danger of injury when unintention-
ally actuating the On/Off switch.
Open the keyless chuck by turning in rotation
direction
Ԯ
, until the tool can be inserted.
Insert the tool.
Firmly tighten the collar of the keyless chuck
by hand in rotation direction
ԯ
. This automat-
ically locks the drill chuck.
Dust/Chip Extraction
► Dust from materials such as lead-con-
taining coatings, some wood types,
minerals and metal can be harmful to
one’s health and cause allergic reac-
tions, lead to respiratory infections and/
or cancer. Materials containing asbestos
may only be worked by specialists.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 fi lter-class
respirator. Observe the relevant regulations in
your country for the materials to be worked.
► Prevent dust accumulation at the work-
place. Dust can easily ignite.
Operation
Starting Operation
Inserting the battery
Note: Use of batteries not suitable for the
machine can lead to malfunctions of or cause
damage to the power tool.
Set the rotational direction switch to the centre
position in order to avoid unintentional start-
ing. Insert the charged battery into the handle
so that it can be felt to engage and faces fl ush
against the handle.
Reversing the rotational direction (see fi g-
ure B)
The rotational direction switch is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch actuated.
Rotate clockwise: Move the rotational direc-
tion switch on both sides up to the stop into
position .
Rotate anticlockwise : Move the rotational di-
rection switch on both sides up to the stop
into position .
Setting the operating mode
Drilling
Set the operating mode selector switch to the
“drilling” symbol.
Screwdriving
Set the torque selector setting ring to the
“screwdriving” symbol.
Impact drilling
Set the operating mode selector switch to the
“impact drilling” symbol.
Switching On and Off
To start the machine, press the On/Off switch
and keep it pressed.
The LED lights up when the On/Off switch is
halfway or fully pressed, and enables illumi-
nation of the screwing location in unfavorable
light conditions.
Adjusting the Speed
The speed of the switched-on power tool can
be variably adjusted, depending on how far
the On/Off switch is pressed.
Light pressure on the On/Off switch results in
a low rotational speed. Further pressure on
the switch results in an increase in speed.
Setting the torque
With the torque preselection ring , the re-
quired torque can be preselected in 17 steps.
The inserted tool is stopped as soon as the
set torque is reached.
Gear selection, mechanical
► The gear selector can be actuated at
standstill or when the machine is run-
ning. However, this should not be done
while operating at full load or maximum
speed.
1st gear:
Low speed range; for working with large drill-
ing diameters.