P.I.T. PP0180-C1, Руководство по эксплуатации

Страница: 7 / 23

Polisher Machine
6
cause allergic reactions and/or lead to re-
spiratory infections of the user or bystand-
ers.
Certain dust, such as oak or beech dust,
is considered carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked
by specialists.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 fi lter-class
respirator.
Observe the relevant regulations in your
country for the materials to be worked.
► Prevent dust accumulation at the work-
place. Dust can easily ignite.
Operation
Starting Operation
►
Observe correct mains voltage! The
voltage of the power source must
agree with the voltage specifi ed on the
nameplate of the machine. Power tools
marked with 230V can also be operated
with 220V.
Switching On and Off
To save energy, only switch the power tool on
when using it.
To start the power tool, press the On/Off
switch forward and then down.
To lock-on the pressed On/Off switch, push
the On/Off switch further forward.
To switch off the power tool, release the On/
Off switch, or when it is locked, briefl y press
the On/Off switch and then release it.
► ACheck grinding tools before using.
The grinding tool must be mounted
properly and be able to move freely.
Carry out a test run for at least one
minute with no load. Do not use dam-
aged, out of centre or vibrating grinding
tools. Damaged grinding tools can burst
and cause injuries.
Speed preselection
The required speed can be preselected with
the thumbwheel (also while running).
The required speed depends on the material
and the working conditions and can be deter-
mined through practical testing.
Working Advice
► Before any work on the machine itself,
pull the mains plug.
► Clamp the workpiece if it does not re-
main stationary due to its own weight.
►
Do not strain the machine so heavily
that it comes to a standstill.
► After heavily straining the power tool,
continue to run it at no-load for several
minutes to cool down the accessory.
Flap Disc
Polishing
For the polishing of weathered paint or buff -
ing out scratches (e.g., acrylic glass), the
machine can be equipped with appropriate
polishing accessories such as lamb’s wool
bonnet, polishing felt or sponge (accessories).
Select a low speed for polishing in order to
avoid excessive heating of the surface.
Apply the polish onto a somewhat smaller
surface than you intend to polish. Work the
polishing agent in with a suitable polishing
tool applying it crosswise or with circular mo-
tion and moderate pressure.
Do not allow the polishing agent to dry out
on the surface, otherwise the surface can be-
come damaged. Do not subject the surface to
be polished to direct sunlight.
Clean the polishing accessories regularly to
ensure good polishing results. Wash out pol-
ishing accessories with a mild detergent and
warm water; do not use paint thinner.
Maintenance and Cleaning
► Before any work on the machine itself
(e. g. maintenance, tool change, etc.) as
well as during transport and storage,
remove the battery from the power tool.
There is danger of injury when unintention-
ally actuating the On / Off switch.
► For safe and proper working, always
keep the machine and ventilation slots
clean.
When the battery is no longer operative,
please refer to an authorised after-sales ser-
vice agent for P.I.T. power tools.
Dispose of waste
Damaged power tools, batteries, ac-
cessories and waste packaging mate-
rials must be recycled and reused in
an environmentally friendly manner.
Do not throw power tools and accumulators /
batteries into general household waste!
Product serial number interpreta-
tion
The fi rst and second digits of the product seri-
al number from left to right