P-Com AirPro Gold, Руководство по установке оборудования

Страница: 6 / 54

FCC NOTICE TO USERS
This device complies with Part 15.247. Assigned FCC Registration Number (FRN) is 0005-8888-70.
This equipment has been tested and found to comply with the limits for a class B device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and , if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interfernce to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the seperation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experinced radio/TV technician for help.
IN ACCORDANCE WITH FCC PART 15
OPERATION IS SUBJECT TO THE FOLLOWING CONDITIONS:
USER
1.) Professional installation required.
2.) The antenna(s) used for this transmitter must be fixed-mounted on outdoor permanent structures with a separation
distance of at least 2 meters from all persons and must not be co-located or operating in conjunctionwith any other antenna
or transmitter.
INSTALLER
1.) Professional installation required.
2.) The antenna(s) used for this transmitter must be fixed-mounted on outdoor permanent structures with a separation
distance of at least 2 meters from all persons and must not be co-located or operating in conjunction with any other antenna
or transmitter.
3.)The maximum peak outdoor power of the intentional radiator shall not exceed 1 watt (+30dBm). In addition, this
system operating in the 2400-2483.5 Mhz band may employ transmitting antennas with directional gain greater than 6
dBi provided the maximum peak outdoor power of the intentional radiator is reduced by 1 dB for every 3 dB that the
directional gain of the antenna exceeds 6dBi.
Product Output Power selection setting instructions:
a.) Connect a PC (serial port) to the unit’s front panel Computer Port. This port is a standard RS-232 inerconnection. (See
section A-7 of the installation manual)
b.)Configure Output Power setting via:
1.) Hyper-Terminal
- Baud Rate 115200
- Data Bits 8
- Parity None
- Stop Bits 1
- Flow Control Hardware
Establish a terminal session, at the Command Line Interface; enter Pwr and the Power Selection. Reboot the system by
entering BOOT, then ENTER. It is not necessary to power down the unit.
2.) P-Com’s proprietary installation software-Site Manager
See Site Manager instuction manual for Output Power Setting configuration.