"BLT 160”
ユーザーマニュアル
/
/ USER MANUAL
改訂版
. n° 5 - 19/07/2011
P.B.M.
S.r.l
via Barella, Z.I. - VIGNOLA ( MO ) ITALIA
Tel. + 39 059 770 53 11 - Fax + 39 059 770 53 00
http://www.gruppopbm.it e-mail: [email protected]
: MU001033GJ_BLT160_GB_JAP rev5_190711.doc
P. 3
A)
INSTALLATION AND SAFETY GUIDELINES
READ THE FOLLOWING INSTRUCTIONS CAREFULLY
before connecting the discharger to mains and battery
.
•
Skilled and authorized personnel only shall be allowed to open the BLT160 discharger
•
Before setting the BLT160 discharger at work the insulation of power cord and charging cable has
to be checked.
•
Disconnect from mains before connecting or disconnecting the battery or the battery charger.
•
WARNING!!
While being charged batteries usually produce explosive gases. It is therefore
highly recommended:
a) Not to smoke in the discharger whereabouts and to keep any flames or
sparks away from it.
b) Carry out test activities / battery and BLT160 use only in properly
ventilated places where there is no possibility of emitted gas saturation.
•
WARNING!!
The BLT160 discharger site must be chosen carefully, considering that the
device contains electrical components, which produce voltaic arcs. The discharger must not
be exposed to rain or splashed with water. It must be firmly positioned on flat and solid
floors and far from dusty environments and any heating sources. The BLT160 discharger
must not be positioned onto supports and / or shelves made of wood or other inflammable
materials. The device position should also promote the thermal exchange between the
discharger and the environment which ensures device reliability.
A minimum of 1m of free
space has to be maintained from its front and rear sides.
•
WARNING!!
Ensure that an adequate earth connection is made
to prevent risks of
electrocution. Check the rating plate to ensure that the AC input supply corresponds to the
discharger’s parameters given on the rating plate. The AC input supply has to feature a
protective device (fuse or automatic cut-out) complying with European Standards. The
rating of the protection fuse or cut-out must be at least 10% higher than the consumed
power of the discharger, as indicated on its rating plate.
Position the BLT160 at least 3 metres from the batteries to reduce the risks deriving
from corrosive gas intake emitted by the battery.
•
WARNING!!
While operating, the rear surface of the discharger can reach very high
temperatures.
Avoid touching the discharger surface without proper heating
protection and always keep a free space of at least 1 m from the device.
In operating conditions, the parts signalled with this indicator can reach the
temperature of 70°C ( IEC 60417-5041 with atmospheric temperature 50°C )
•
The P.B.M. S.r.l. charging device requires no special maintenance, except for routine cleaning by blowing
air, which should be done regularly and periodically depending on the type of work place.
Before starting to clean the device, disconnect the power cable from the mains and the connection
cables from the battery.
