6
NOTE:
DO NOT CONNECT THE AC MAINS END OF THE AC MAINS CABLE IN AN AREA THAT IS WET OR SUBJECT TO
CONDENSATION OR DAMP CONDITIONS!
Once the AC mains cable is securely connected to both the amplifier and AC mains supply, the amplifier may be turned on. It is
good practice to make certain that the audio levels on the mixer’s output (or other source output) are reduced or muted prior to
applying power. The pilot light is located on the rear panel.
NOTE:
If the pilot light does not illuminate within 30 seconds the unit may be in a FAULT CONDITION. If this occurs, the
unit should be returned to P.Audio for evaluation.
THERE ARE NO USER-SERVICABLE PARTS INSIDE. DO NOT REMOVE THE AMPLIFIER MODULE!
(See the section below
“Replacement of Components” for more detailed information).
3.2.
AUDIO
CONNECTIONS
The XT amplifiers include both male and female XLR-type connectors, and speakon connectors. Any standard XLR-type cable end
connectors may be used.
The image below illustrates the inputs found on the amplifier plate. Line Input and Line Output (THRU) are shown. All the necessary
EQ is provided in the on board pre amp. A line level input of voltage 0.775v will drive the on board amplifiers to full power.
The XT input section also allows for “paralleling” multiple powered enclosures together. This function is achieved by using the Line
Output XLR-type connector located next to the input XLR-type connector on the amplifier module.
The output level can be
controlled using the level control knob, or using remote software (see section REMOTE SOFTWARE).
The preset EQ may be adjusted to match one of the cabinets in the XT series (presets 1-4), the 3LINE-C enclosure (Preset 5), user
presets adjusted with the remote control software (presets 6,7) or pink noise (preset 8). The pink noise preset is useful as a locator
in case the knob is lost, and also for system set up.
Содержание XT Series
Страница 1: ...P AUDIO XT SERIES MANUAL...
