OZtrail CTC-1008-C, Руководство пользователя

Страница: 6 / 16

6
ASSEMBLY INSTRUCTIONS
IMPORTANT
the parts.
See page 12 - CONDITIONING YOUR NEW CANVAS TENT/SHELTER
STEP 1:
Select a sheltered camp site protected from the wind that will not allow water to pond under the tent floor.
Clear a level area of all stones, twigs, etc.
Open doors and windows to allow air inside when standing tent up.
WARNING
Failing to open doors and windows will put excessive stress on the fabric as the tent is raised and
may cause damage. This damage is not covered by warranty.
Peg down the corners of the tent. See Figure 1. Peg down all remaining peg loops.
STEP 2: Install the ridge poles
Select the three ridge poles (301), slide one ridge pole through the sleeve that runs along the centre of the roof.
Slide the remaining ridge poles through the loops along both sides of the roof. Make sure that you do not miss
any loops including the webbing loops . See figure 1.
WARNING
Do not force poles through the sleeves as this may damage the sleeve. Check to ensure the pole
does not snag when sliding it through the sleeve.
STEP 3: Install the upright poles
Select the 4 corner poles 2 x 060 & 2 x 010 short and the 2 centre Ridge Poles 2 x 011 long. Fold the awning
into the centre Ridge Pole the same way, then insert the 010 into right hand Ridge Pole the same way. Note that
the 010 Poles are adjustable. This allows you to move the poles away from the doorways while extending them
Ridge Poles and the 011 long is for the centre Ridge Pole. See figure 2.
STEP 4: Standing the tent up
wall is fully upright and the corner upright poles (010) support the side of the tent. Repeat this for the other
side of the tent, the tent should now be supported by the four corner uprights (010). Connect the two centre
WARNING
Do not push the poles up too high as this may cause damage to the fabric. This damage is not
covered by warranty.