8
Step 1 Foam dust seal
Please note the dust seal is optional and not included.
Glue a foam dust seal onto the top rim of your trailer. The
top rim of most trailers is approximately 5cm wide and it
is best to position the dust seal in the centre.
CAMPER TRAILER TENT PLACEMENT ON TRAILER
Step 2 Place the camper
trailer tent onto your trailer
HELPFUL HINT
To avoid the risk of injury you should employ
the help of at least three others to lift your
Camper Trailer Tent onto the trailer and
position it.
X
Figure 9
Camper Trailer Tent flush
with rear of trailer
Model logo
Firstly, stabilise and level your trailer, making sure it will
not move as you work on it. With your three helpers
lift the Camper Trailer Tent onto the trailer. The Camper
Trailer Tent needs to be placed so that it folds out to the
side of the trailer, (For the Camper Trailer Tent 8 models, it
folds out to the rear of the trailer). Using a tape measure
centralise the Camper Trailer Tent on the trailer with the
base board flush with the rear of the trailer, see Figure
9. Always lift the Camper Trailer Tent, do not slide it
otherwise this could damage the finish on the top rim of
the trailer or the dust seal if fitted.
Attaching the Camper Trailer
Tent to trailer Instructions
Tools you will need
;
Drill
;
8mm drill bit for wood and steel.
;
Spanners to fasten bolts and nuts.
;
Large Phillips screwdriver.
;
Foam sealing tape (optional at
owner’s decision and expense)
Ensure Camper Trailer Tent does
not extend past edge of mudguard
