Ozone Solos, Руководство пилота

Страница: 9 / 27

EN
06
SPEED SYSTEM
A lightweight integrated speed-line is included as standard. The speed system is already installed by the factory but if you ever need to replace it
follow these steps.
Route the line down through the small reinforced slit found on the outside of the side panel.
Pass the line through the Ronstan pulley
Then through the small opening and metal ring at the front of the seat plate.
Ensure that the lines run cleanly through the pulleys and pass to the outside of all structural webbing straps.
Attach the bar with a suitable knot. Once in the air, and when it is safe to do so, check that you can place your
foot on the bar easily and that the system operates smoothly all the way to full speed.
IMPORTANT: The speed bar lines must be of equal length, ensure they are not too short
as this will inadvertently activate the speed system when under tension in the air. Always double-check lengths and
symmetry whilst on the ground before flying.