USER MANUAL EN
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OZONE
GENERATOR
.
This ozone generator produces ozone gas. Ozone gas is toxic and hazardous to human and
animal health in concentrations that exceed the OSHA (Occupational Safety and Health
Administration) set exposure limits.
During ozone treatment, the ozone concentration may under certain conditions, quickly
exceed these set limits. Read section 1 to section 8 on the following pages to perform a
safe ozone treatment.
Safety regulations
Check the product before use. The ozone generator must not be used if the
appliance, the power cable, or the insulation seems damaged. If in doubt, contact
the manufacturer. The generator contains electrical components and must
therefore always be placed dry, never to be exposed to excess humidity, water
splashes or running water. For all types of service or maintenance, the generator
must always be disconnected from power. Ozone gas is toxic, so be aware of
recommended room sizes.
Recommended room sizes
Ozone has a characteristic chlorine-like odor. The gas is toxic and will, in high
concentrations, irritate the eyes and respiratory tract. The limit value for ozone
gas is set at 0.1PPM for exposure up to 8 hours per day, or 0.3PPM for a
maximum of 15 minutes. If the generator is used in a room that has a volume of
less than 40 m3 and poor ventilation, the ozone concentration may exceed the
mentioned limit values. Then it is important to make sure that the room is well
ventilated before it can be reoccupied. If people or animals are in a room at the
same time as it is ozonated, an ozone sensor must be installed which
automatically switches off the power to the ozone generator if the ozone
concentration in the room gets too high (above 0.1PPM).
Odor removal
–
Approach
The generator is placed on a stable surface or hung on a wall (fig. 3) in a dry place,
preferably about 1.5 meters above the floor. Check that air supply to the
generator and exhaust from the generator remains uncovered / open. Close all
windows and valves. Empty the room of people, animals, and live plants.
Page 3
Connect the generator to power and start the generator with the red main switch
(fig. 1). You will hear the fan start and a faint hum from the ceramic item. A green
LED will indicate that the generator is producing high voltage (Fig. 1). You can also
see through the exhaust grille that the ceramic element gives off a faint blue
glare. The odor remediation effect is a function depending on time. The generator
can run continuously for a week without any problem. For longer operation, we
recommend that you use a simple timer and run the generator at shorter
intervals. This will also reduce future need for maintenance.
Service and maintenance
Service-Kit
can be ordered through your dealer or manufacturer.
Make sure that the generator is not connected to power before starting work.
Filter:
The thin particle filter in front of the fan should be cleaned regularly. The
filter cover is only clamped and can be loosened gently with your nails or a small
screwdriver. Vacuum and / or wash it in mild soap and dry well before putting it
back (fig. 4).
Ceramic element
This is a consumable part. Estimated service life
›
3500 hours, depending on air
quality / humidity. As long as it emits a blue glare, it produces ozone gas. For best
effect, we recommend regular cleaning.
Cleaning:
Wipe the item with a q-tip or fine cloth dampened with window cleaner
or rubbing alcohol (Fig. 5). Wipe with a dry cloth afterwards. The appliance must
be completely dry before it can be restarted.
Replacing the ceramic element:
Loosen the 4 screws that hold the element.
Loosen the quick connectors of the 2 red wires (fig. 6). Release the red wire from
the green LED that is attached with 2 cable strips to one of the element's red
wires. Fit the new element, remember the 4 spacer sleeves under the element
when you fasten the 4 screws carefully. Connect the 2 quick connectors - then
fasten one wire from the green LED lamp carefully along one of the element's red
wires with 2 new cable strips.
Other components
: All other service must be performed by the manufacturer.
