Ozone OCTANE, Руководство пилота

Страница: 16 / 43

LANDING
PACKING YOUR PARAGLIDER
1. Lay the glider out on its top surface, check the lines are not tangled, then lay
them on the wing, free of kinks. The risers should be laid together at the centre
of the trailing edge.
2. Fold the wing from each tip to the centre cell by cell, making sure that the
leading edge is in one straight line, until it is one or two cells wide.
3. Push any remaining air out by flattening the folded wing from the trailing edge
to the leading edge.
4. Make four or five folds from the trailing edge up to the leading edge so that the
bundle is approximately the size and shape of the OZONE rucksack. Never roll
the wing up as this introduces unnecessary stresses into the fabric. Finally, wrap
the velcro band around the bundle and put it in the rucksack.
Note: Making sure not to pack the paraglider too tightly and taking care that the
leading edge is folded carefully will increase its life. Always pack as loosely as
you can, while still being able to fit it in the rucksack - every fold weakens the cloth
on any paraglider. It is best not to keep folding the glider along the same lines, so
don't worry if it is not completely tidy every time.
Light wind: The landing approach should be flown using only light input on the
brakes. When you are one or two metres above the ground, apply the brakes
progressively so that the full brake position is attained just before your feet touch
down. Always approach with plenty of speed so that it that can be converted into
a full flare.
Strong wind: You should regulate your speed facing into wind. Use the minimum
of brake needed to touch down smoothly, then immediately turn 180 degrees,
reach up and pull down both C-risers while moving towards the glider. This will
bring the wing down quickly without pulling you off your feet.
IMPORTANT: Always land into wind in a clear obstacle-free zone.
10