SET-UP
APEX V1 BOARD USING TITANIUM T-NUT
DECK WASHERS:
1: Fit the 4x T-Nut Deck Washers into the board slots.
2: Fit the 4x T30 28mm Custom Titanium Screws into the T-Nut Deck
Washers. Turn each screw one full rotation to get the thread started.
3: Slide the screws and washers to the ends of the board slots.
4: Place the mast on the board and align the slots.
5: Slide each screw into the slot on the mast, ensuring the T-Nut Deck
Washers remain connected.
6: Slide the screws until they fit at the countersunk section of each slot
on the mast.
7: Firmly hand tighten each screw (approx. 8N.m torque wrench setting)
MAST TO BOARD
FUSELAGE TO MAST
OTHER BOARDS WITH US BOX USING M6 T-NUTS:
1: Assemble the 4x T30 28mm Custom Titanium Screws with the T-Nuts.
Turn each screw one full rotation to get the thread started.
2: Fit the screw and T-Nuts into the US box.
3: Slide the screws and T-Nuts to the ends of the tracks.
4: Place the mast on the board and align with the tracks.
5: Slide each screw into the slot on the mast, ensuring the T-Nuts remain
connected.
6: Slide the screws until they fit at the countersunk section of each slot
on the mast.
7: Firmly hand tighten each screw (approx. 8N.m torque wrench setting)
1: Fit the Fuselage onto the Mast tuttle.
2: Push the Fuselage down until the fit feels snug and
it can not be pushed further.
3: Align the 2x T30 22mm Custom Titanium Screws
with the Barrel Nuts inside the Mast and begin to
tighten. Ensure the screws are threaded correctly.
4: Tighten each screw a few turns at a time so they
tighten evenly and slowly pull the Mast tuttle into
the Fuselage.
5: Firmly hand tighten each screw (approx. 8N.m
torque wrench setting)
FRONT WING TO FUSELAGE:
1: Fit the Front Wing onto the Fuselage.
2: Align the 2x T30 **mm Custom Titanium screws with
the Barrel Nuts inside the Fuselage and begin to
tighten. Ensure the screws are threaded correctly.
3: Tighten each screw a few turns at a time so they
tighten evenly.
4: Firmly hand tighten each screw (approx. 8N.m torque
wrench setting)
REAR WING TO FUSELAGE:
1: Fit the Rear Wing onto the Fuselage.
2: Align the 2x T30 **mm Custom Titanium screws with
the Barrel Nuts inside the Fuselage and begin to
tighten. Ensure the screws are threaded correctly.
3: Tighten each screw a few turns at a time so they
tighten evenly.
4: Firmly hand tighten each screw (approx. 8N.m
torque wrench setting)
** Refer to the screw pocket inside the wing cover OR online manual for screw length
