SCMS-10STAND
4. OPERATING THE SAW
Turning On and Off
1. To turn the mitre saw on,
squeeze the trigger switch.
2. To turn the mitre saw off,
release the trigger switch.
Laser Guide
It is extremely important to
always secure the workpiece
properly and tightly with the
material clamp.
Note:
Before performing a cut, ensure the blade is at full speed.
Failure to do this may cause the blade to become blunt and cause
the blade to lock-up.
Slide Action
When cutting wide pieces of
wood, ensure the slide lock is
loose.
1. First slide the saw fully towards you, slide the release lever
right with your thumb and press handle down.
2. Push carriage toward the rear fence.
Place the workpiece flat on the
mitre table with one edge securely
against the rear fence.
Note:
If the workpiece is warped,
ensure the concave (curves inward)
side is against the rear fence.
Workpiece
WARNING!:
DO NOT STARE DIRECTLY AT
THE LASER BEAM.
2. To switch the laser guide on,
press the laser guide switch to
the On position.
3. To switch the laser guide off,
press the laser guide switch to
the Off position.
Note:
Ensure that the laser guide is switched off when the saw is
not in use.
Note:
If the laser is not aligned correctly with the blade, this can be
adjusted (see ‘Saw Alignment’ section).
Material Clamp
A laser line is projected onto the material you wish to cut, providing
an exact guide for the cut.
1. 2 x AAA batteries must first be inserted into the laser battery
compartment. Ensure the batteries are in the correct direction.
