MAINTENANCE
9
•
Keep the ventilation slots of the reciprocating saw clean at all times. If possible
prevent foreign matter from entering the vents.
•
After each use, blow air through the saw to ensure it is free from all dust particles
that may build up. A build up of dust particles may cause the tool to overheat
and fail.
•
If the enclosure of the reciprocating saw requires cleaning do not use solvents
but a moist soft cloth only. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
•
When the carbon brushes wear out the tool will spark and/or stop. The brushes
are a wearing component of the tool and should be replaced prior to the
carbon wearing out fully. Brushes will wear out after many uses but before they
do take the tool to an electrician or a power tool repairer for quick and low
cost replacement. Always replace both brushes at the same time.
Carbon brushes
When the carbon brushes wear out, the tool will spark
and/or stop. Discontinue use as soon as this happens. They
should be replaced prior to recommencing use of the tool.
Carbon brushes are a wearing component of the tool
therefore not covered under warranty. Continuing to use the
tool when carbon brushes need to be replaced may cause
permanent damage to the tool. Carbon brushes will wear
out after many uses but when the carbon brushes need to
be replaced, take the tool to an electrician or a power tool repairer for a quick and
low cost replacement. Always replace both carbon brushes at the same time.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by
the repair of the saw by an unauthorised person or by mishandling of the saw.
Limited spare parts are available subject to availability. Please contact your local
Bunnings Special Orders Desk to order the required spare parts.
Most common spare parts listed below
Spare Part
Part No.
Carbon Brushes (set)
SPRSR850-49
Carbon Brush Holder (set)
SPRSR850-50
Speed Controller SPRSR850-58
Switch
SPRSR850-59
Carbon brushes
SPARE PARTS
