Ozito RSH-100, Инструкция по эксплуатации

Страница: 11 / 20

OPERATION (cont.)
Safety Interlock
The shredder is fitted with a safety switch on the closure
between the shredder housing and motor housing (Fig. 13).
This acts as a safety mechanism to prevent the shredder
from operating if it is not closed correctly.
- If the housing is not closed correctly and secured with the
locking knob (3), the safety switch will prevent the shredder
from being turned on.
- If this occurs disassemble the housing and ensure the
contact surfaces are clean. Refit and tighten the locking knob (3) in a clockwise direction.
Take care to correctly line up the thread on the locking knob (3) before tightening to
avoid cross threading.
CAUTION! NEVER loosen the locking knob (3) when the power is on. Always
ensure the power is turned off and pulled out of the mains power.
Replacing Blades
The blades supplied with the shredder are reversible. The blades can also be
re-sharpened if they become blunt over a period of time.
CAUTION: Blades (20) are sharp, handle with care, it is recommended to use
gardening or safety gloves when handling the blades (20).
To remove the blades proceed as follows:
1. Ensure the shredder is turned off and pulled out of the
mains power. Unscrew the locking knob (3) in an anti-
clockwise direction (Fig. 14). The thread on the locking
knob is quite long, the operation will require approximately
3 rotations to fully open the housing.
2. After unscrewing the locking knob (3) lift the housing
upwards (Fig. 15) to gain access to the cutting blades.
3. Using the spanner/screwdriver (12), lock the cutting head
by placing the spanner/screwdriver (12) through the
slot (Fig. 16).
10
Fig. 13
Fig. 16
Fig. 14
Fig. 15
RSH-100 Manual.qxd 1/11/11 1:01 PM Page 11