ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
required
drilling
depth
KNOW YOUR PRODUCT
1. USING THE DEPTH ROD
The depth rod allows you to drill to a predetermined depth.
1. Loosen the depth rod
securing nut then insert
depth rod.
4. Drill the hole until
the end of the
depth rod touches
the workpiece.
3. Tighten the depth
rod securing nut to
lock the depth rod
into place.
2. Adjust the depth
rod so the drill bit
extends beyond the
end of the depth
rod to the required
drilling depth.
1 SDS
+
Accessory Holder
2 Accessory Locking Sleeve
3 Magnesium Gear Case
4 Side Handle
5 Depth Rod Locking Knob
6 Side Mode Selector
7 Grease Cap
8 Rear Mode Selector
9 On/Off Switch
10 Soft Grip Rear Handle
ROTARY HAMMER DRILL
11 Depth Rod
12 3 x SDS
+
150mm Drill Bits
13 1 x SDS
+
Flat Chisel
14 x 250mm
14 1 x SDS
+
Point Chisel
14 x 250mm
15 Dust Cover
16 Tub of Grease
17 Pin Spanner
ACCESSORIES
SETUP & PREPARATION
Ensure the tool is disconnected from the power supply before
performing any of the following operations.
