Cleaning
• We recommend that you clean the appliance immediately after you
use it.
• Keep the safety devices, air vents, and the motor housing free of dirt
and dust as much as possible. Wipe the equipment with a clean cloth.
• Do not use cleaning agents or solvents; these may be aggressive to
the plastic parts in the appliance.
• The tank can be cleaned with a damp cloth and some soft soap or
under running water, depending on the amount of dirt.
• Clean the foam filter with a little soft soap under running water and
allow it to air-dry.
Storage
Ensure the Wet & Dry Vac has been fully emptied of any dry matter
or liquid before it is stored.
Keep all the accessories with the unit to avoid losing them. The 2-in-1
surface tool and 2-in-1 crevice tool can be stored in the accessory storage
slots. Ensure the accessories are mounted securely on the slot; press the
tools firmly onto the slot to ensure they do not wobble and fall off.
Keep in a dry place out of reach of children.
Note:
Ozito Industries will not be responsible for any damage or
injuries caused by repair of the staple nail gun by an unauthorised person or
by mishandling.
WARNING!
BEFORE CLEANING OR CARRYING OUT
ANY MAINTENANCE PROCEDURE, ENSURE THAT
THE BATTERIES HAVE BEEN REMOVED.
MAINTENANCE
DESCRIPTION OF SYMBOLS
V
Volts
L/s
Litres per second
mbar
Millibar
Double Insulated
Warning
Regulatory Compliance Mark
(RCM)
Read Instruction Manual
Power tools that are no longer usable should not be disposed
of with household waste but in an environmentally friendly
way. Please recycle where facilities exist. Check with your local
council authority for recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution in the
environment. Please recycle packaging where facilities exist.
Check with your local council authority for recycling advice.
CARING FOR THE ENVIRONMENT
SPARE PARTS
Spare parts can be ordered from the Special Orders
Desk at your local Bunnings Warehouse.
For further information, or any parts not listed here,
visit www.ozito.com.au or contact Ozito Customer
Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
WARNING!
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY IS REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
Problem Cause
Remedy
Vacuum is
not starting
Battery charge is low
Charge battery
Battery not inserted
properly
Insert battery pack correctly
Possible clogging
Empty the debris container and
clean the filter.
Vacuum
is not
operating at
full capacity
Possible clogging
Empty the debris container and
clean the filter.
Motor
stops while
vacuuming
Battery has no power
Charge battery
TROUBLESHOOTING