4. ATTACHING THE ACCESSORIES
3. FITTING THE BATTERY & GUIDE
Inserting & Removing the Battery (not included)
1 Align the ribs of the battery
with the recess at the back
of the handle.
3 To remove, press and hold
the battery release tab and
then slide out.
2 Slide the battery
into the seating until
it clicks into place.
The parallel guide assists in cutting in a line parallel to an edge.
2 Slide the parallel guide
into the slots under the
locking screws.
1 Unscrew the guide
locking screws
at the front of the
jigsaw.
3 Tighten the guide locking
screws to secure position.
Attaching the Parallel Guide
The splinter guard ensures that the workpiece does not splinter
and crack while cutting.
The line guide helps maintain a straight line while cutting at a
90
0
or 45
0
angle.
3 To Remove, squeeze the
sides of the guard and then
pull the splinter guard away
from the base.
WARNING!
THE SPLINTER GUARD CAN ONLY BE USED
WHEN CUTTING AT A 90
0
ANGLE TO THE WORKPIECE.
Using the Splinter Guard
Using the Line Guide
1 Slide the front of the
splinter guide into the
recess on the base of the
jigsaw.
1 place the 2 hooks of the
line guide over the rail at
the front of the jigsaw.
2 Squeeze the sides of the
guard to allow the back to
be pushed into place.
2 Push the line guide down
until it clicks into place to
allow the line guide to be
flush with the base of the
jigsaw..
