KNOW YOUR PRODUCT
SETUP & PREPARATION
1. ASSEMBLY
CORDLESS ANGLE GRINDER
1
2
3
4
5
6
1 Spindle Lock
2 Guard Locking Screw
3 Side Handle
4 Lock On Slide Switch
5 Sure Grip Handle
6 Battery Seating
7 Pin Wrench
1 Loosen the safety guard locking
screw to allow the guard to spin.
The safety guard is pre-fitted to the angle grinder ready for use. The position
of the guard can be adjusted following the steps below using a hex key (not
supplied).
3 Tighten the safety guard locking
screw to secure in position.
1 To fit, screw the side handle
clockwise into 1 of 3 handle
positions.
2 Rotate the guard into the desired
position.
2 To remove, screw the handle
anti-clockwise.
Fitting and Removing the Side Handle
Safety Guard
WARNING!
ENSURE THE TOOL IS SWITCHED OFF AND
THE BATTERY IS REMOVED BEFORE PERFORMING ANY
OF THE FOLLOWING TASKS.
WARNING!
DO NOT OPERATE THE ANGLE GRINDER
WITHOUT THE SAFETY GUARD FITTED AS POSSIBLE
INJURIES COULD OCCUR.
7
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to the
online manual.
BATTERY & CHARGER
This tool is compatible with all battery and chargers from the Ozito
Power X Change Range.
For optimal performance, we recommend the use of a 3.0Ah battery or
higher to operate this Power X Change Angle Grinder.
