FWD
REV
3. KEYLESS CHUCK
4. CONTROLS
OPERATION
Speed Control
1 Slide the switch forward to select
first gear.
2 Slide the switch backward to
select second gear.
The gear selector controls the speed of the drill. First gear allows slower drilling
with more torque, while second gear is suitable when less torque but higher speed
is required.
WARNING!
ENSURE THE TOOL IS SWITCHED OFF AND
DISCONNECTED FROm THE POWER SUPPLY BEFORE
PERFORmING ANY OF THE FOLLOWING TASkS.
CAUTION!
TO REDUCE THE RISk OF INjURY, WE
RECOmmEND THE USE OF GLOVES WHEN HANDLING
DRILL BITS.
Forward/ Reverse Lever
Variable Speed Trigger
1 For forward rotation, push the fwd/rev lever towards the left side of the drill. For
reverse rotation push fwd/rev lever to the right.
1 To start drilling squeeze the variable
speed trigger.
2 To stop drilling release the trigger.
Note:
The more the variable speed trigger is depressed, the faster the drill bit will
rotate.
Adjusting Torque
1 Rotate the torque collar to the desired setting.
Note:
Selecting a higher torque setting will allow the drill to use more torque to drive
the screw in or out. To prevent damaging the screw head, it is recommended to
start at a low torque setting and increase when necessary.
Installing a Drill Bit
Removing a Drill Bit
1 Open the chuck by rotating the
chuck collar and remove the
drill bit.
2 Insert the drill bit,
making sure it
is centred in the
chuck.
4 Pull on the bit to
ensure it is firmly
secured.
1 Rotate the chuck collar anti-
clockwise to open the chuck.
3 Tighten the chuck by turning
clockwise.
