1
PBL-030
5. OPERATING THE BLOWER
MAINTENANCE
6. GENERAL MAINTENANCE
Cleaning
• Use a soft brush to remove
debris from all air intakes.
• Wipe the surface with a dry
cloth.
• Never use water for cleaning
your blower. Most plastics are
susceptible to damage from
various types of commercial
solvents. Use clean cloths to
remove dirt, dust, oil, grease, etc.
• If the blower vibrates abnormally, stop motor immediately. Abnormal
vibration usually indicates a mechanical problem continued operation
could lead to injury or damage.
Note:
Ozito Industries will not be responsible for any damage or injuries
caused by repair of the tool by an unauthorised person or mishandling
or mistreatment of the blower. This tool is designed for DIY use - use in
commercial or industrial environments will void the warranty.
WARNING!
BEFORE EACH USE, INSPECT THE ENTIRE
PRODUCT FOR DAMAGED, MISSING OR LOOSE PARTS,
SUCH AS SCREWS, NUTS, BOLTS, CAPS, ETC. TIGHTEN
SECURELY ALL FASTENERS AND DO NOT OPERATE
THIS PRODUCT UNTIL ALL MISSING OR DAMAGED
PARTS ARE REPLACED.
WARNING!
ENSURE THE BLOWER IS SWITCHED OFF AND
ALLOWED TO COOL DOWN BEFORE PERFORMING ANY
OF THE FOLLOWING OPERATIONS.
WARNING!
DO NOT USE THE BLOWER WITH ANY
TYPE OF ACCESSORY OR ATTACHMENT. SUCH USAGE
MIGHT BE HAZARDOUS.
WARNING!
DO NOT PUT PART OF YOUR BODY SUCH AS
HANDS AND FINGERS IN THE VACUUM OPENING
OR EXHAUST OPENING.
WARNING!
DO NOT SWITCH THE MACHINE ON IN
ENCLOSED OR POORLY VENTILATED SPACES OR IN
THE PRESENCE OF FLAMMABLE AND/OR EXPLOSIVE
LIQUIDS, GASES AND POWDERS.
Blowing
The blower is ideal for blowing
leaves, grass clippings and other
debris.
Hold the blower firmly, point the
jet of air in front of you and move
forward slowly. Move the blower
from side to side, with the nozzle
several inches above the ground.
Be careful where you point the
jet of air as it can move heavy
material and cause injury or
damage to bystanders.
Note:
Be aware of other people
and animals in the area where you
are to be operating the blower.
Note:
Avoid collisions with hard objects which could damage your
machine.
Storage
In order to avoid deposits forming on the interior of the carburettor,
follow these instructions:
1. Carry out all of the maintenance work and drain the fuel out
of the tank.
2. When the fuel has been drained, start the engine and allow it to run
at idling speed until it stops. This will clean the remainder of the fuel
out of the carburettor.
3. Leave the machine to cool (approx. 5 minutes).
4. Remove the spark plug.
5. Place a teaspoon full of 2-stroke engine oil into the combustion
chamber. Pull the starter cable several times carefully to wet the
internal components with the oil. Fit the spark plug again.
6. Store the machine in a cold, dry place where it is out of the reach of
ignition sources and inflammable substances.