![background image](http://html1.mh-extra.com/html/ozito/ozrh1100a/ozrh1100a_operating-instructions-manual_1666659010.webp)
•
The grease in the gearbox will require replenishment after
approximately 50 hours accumulative use. After this time add
approximately 50 grams of the grease, into the gearbox. First remove
the cap from the tool by using the pinned spanner (supplied). Once
removed add the grease through this hole. Ensure the cap is secured
back into position prior to operation.
•
After each use, blow air through the tool housing to ensure it is free
from all dust particles that may build up. Build up of dust particles
may cause the tool to overheat and fail.
•
If the enclosure of the tool requires cleaning do not use solvents but a
moist soft cloth only. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
•
When the carbon brushes wear out the tool will spark and/or stop. The
brushes are a wearing component of the tool and should be replaced
prior to the carbon wearing out fully. Brushes will wear out after many
uses but before they do take the tool to an Authorised Ozito Service
Agent for quick and low cost replacement. Always replace both
brushes at the same time.
Note:
Ozito Industries will not be responsible for any damage or injuries
caused by the repair of the tool by an unauthorised person or by
mishandling of the tool.
MAINTENANCE
10