3. When the machine is cold first pull out the choke
control (1) to the CHOKE position, (fully withdrawn).
Note:
Once the choke control (1) has been
pulled out, it cannot be pushed back to the run
position, it returns automatically when the throttle
trigger (4) is operated.
4. Depress the priming bulb (22) 6 times or until the
bulb is full of fuel.
Note:
This is not required if engine is warm or is
being restarted.
5. Hold the chainsaw securely on the ground and
pull vigorously on the recoil starter (9). Repeat (at
least 15 times) until the engine “kicks” (attempts
to start).
6. With the throttle safety lock (3) held depressed
slightly pull on the throttle trigger (4) and then
release it. The choke control (1) will click back
one position.
7. Pull the recoil starter (9) again and restart the
engine. Allow the engine to warm up, for
approximately 1-2 minutes.
8. When the engine is warm first depress the throttle
safety lock (3) then pull fully on the throttle trigger
(4) for a short burst. The choke control (1) will fully retract to the RUN position, the
chainsaw is now ready for use.
9. When restarting the engine when it is still warm, set the choke control (1) to the
START position. Hold the chainsaw securely on the
ground and pull vigorously on the recoil starter (9).
Allow the engine to run for a few moments with the
throttle trigger (4) pulled slightly.
10. When the engine is fully warm, pull on the throttle
trigger (4). The choke control (1) will fully retract to
the RUN position.
11. When ready to start cutting, release the brake, by pulling the front
guard (6) back firmly towards the rear of the saw.
OPERATION (cont.)
RUN
START
15