9
•
Place switch in “O” off position and unplug from the power supply before the
blower is serviced, cleaned or maintenance is performed.
•
Keep air intake clean and air vents free of debris to avoid overheating the motor.
•
Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent
on a damp cloth is recommended. Water must never come into contact with
the tool.
•
If the blower vibrates abnormally, stop motor immediately. Abnormal vibration
usually indicates a mechanical problem continued operation could lead to injury
or damage.
•
No lubrication is necessary as the motor is equipped with lifetime-lubricated bearings.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by
repair of the tool by an unauthorised person or mishandling or mistreatment of the
tool. This tool is designed for DIY use - use in commercial or industrial environments
will void the warranty.
MAINTENANCE
DESCRIPTION OF SYMBOLS
Double insulated
V
Voltage
Regulator compliance mark
Hz
Herts
n
o
No load speed
W
Wattage
/min
Revolutions or
reciprocation per minute
Warning
~
Alternating current
dB
Decibel (noise) rating
CF
Cubic Feet (CF/hour)
Disconnect from power supply
when performing maintenance
Wear Eye, Ear & Breathing
Safety Gear during use
Do not use in wet weather
Be aware of people around you and do not direct
towards them
Read operating instructions
before use
Disconnect and discontinue use
should the power-cord be damaged
