Ozito LTR-300, Инструкция по эксплуатации

Страница: 13 / 16

Fig. 13
a
b
j
f
d
d
1. Turn your line trimmer upside down.
2. Depress both tabs (e) on both sides of the spool housing and remove the spool
cover (a) from the spool housing (c).
3. Remove the empty spool (f) from the spool housing (c).
4. Remove any dirt and grass from the spool cover (a) and spool housing (c).
5. Secure the ends of each line (a) either side into the notches (d) leaving 10cm of
cutting line (a) for feeding into the two eyelets (g).
6. Insert the rewound spool (f) into the spool housing (c). Rotate the spool (f) slightly
until it is seated.
7. Align the tabs (e) on the spool cover (a) with the cut outs in the spool housing (c).
Then push the spool cover (a) back into the spool housing (c) until the clips (e) click
into position.
8. Pull each end of the line (a) to release from the notches (d).
Winding new line onto a spool (Fig. 13)
You may wind new cutting line onto an empty spool. Cutting line is available from any
Bunnings Warehouse. Only use cutting line that is 1.5mm (solid) or 1.6mm (twisted) in
diameter, using different line can result in poor performance or damage the motor.
1. Remove the empty spool from the line trimmer as described above steps 1-4.
2. Remove any remaining cutting line from the spool.
3. Measure no more than 10 metres of new line. Divide the line evenly so you find
the half-way point and cut in half.
4. Place each end of the cutting line through the hole in the spool (b) to lock it in place.
5. Wind the cutting line (a) onto the spool (f) in the direction of the arrow (j). Make
sure to wind the line (a) on neatly and in layers. Do not cross the line as this will
stop it from feeding.
6. Complete winding the line and ensure that the line does not protrude past the end
of the spool (f) edge.
7. Secure the ends of each line (a) either side into the notches (d) leaving 10cm of
cutting line (a) for feeding into the two eyelets (g).
8. Insert the rewound spool (f) into the spool housing (c). Rotate the spool (f) slightly
until it is seated.
9. Align the tabs (e) on the spool cover (a) with the cut outs in the spool housing (c).
Then push the spool cover (a) back into the spool housing (c) until the clips (e) click
into position.
10. Pull each end of the line (a) to release from the notches (d).
13
MAINTENANCE (cont.)