ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
KNOW YOUR PRODUCT
SETUP & PREPARATION
1. BATTERY
Note
: On the initial charge, the battery requires 5 hours of charging.
Subsequent charging only requires 3-5 hours. It will take 4-5 charging
cycles before the battery reaches optimum charge and run time.
1 Keyless chuck
2 Torque adjustment collar
3 LED worklight
4 Variable speed trigger
5 Forward/ reverse lever
6 Battery release button
7 12V Battery
CORDLESS DRILL DRIVER
Installing and Removing
2. Insert battery into charging
cradle. The red light will
illuminate when battery is
properly connected.
Slide the battery into the drill
base until it clicks into place.
1. Plug charging jack into the
charging cradle. The green
light will illuminate when
properly connected.
Charging
Hold down the battery release
buttons and slide the battery out.
8 Charging adaptor
9 Charging jack
10 Charging cradle
11 Adaptor bit
12 Driver bit x 5
3. When the battery is fully
charged, the green light only
will illuminate.
This charger is recommended for use with a residual current
device with a rated residual current of 30mA or less.
Note:
If the battery does not
require charging, the green light
will stay illuminated. The red
light will not come on.
ACCESSORIES
