3. ATTACHING THE ACCESSORIES
The parallel guide assists in cutting in a line parallel to an edge.
The splinter guard ensures that the workpiece does not splinter and
crack while cutting.
2 Slide the parallel guide into
the slots under the locking
screws.
2 To Remove, pull splinter guard
away from the base.
1 Unscrew the guide
locking screws at the
front of the jigsaw.
1 Clip the splinter
guard into the
recesses in the
base of the jigsaw.
3 Tighten the guide locking
screws to secure position.
2. ADJUSTING SHOE ANGLE
The angle of the shoe can be adjusted to allow for bevel cuts between
0 and 45
°
.
WARNING!
thE SPLINtER GUARD CAN ONLy bE USED
WhEN CUttING At A 90
0
ANGLE tO thE WORkPIECE.
Attaching the Parallel Guide
Using the Splinter Guard
2 Slide the shoe
backwards.
5 Secure in place by pulling the
shoe locking lever to the left.
1 Push the shoe
locking lever to the
right to unlock the
adjustable shoe.
4 Once the angle is
correct slide the
shoe foward for the
pin to make contact.
3 Tilt the shoe to the
desired angle using
the measurements.