MAINTENANCE
DESCRIPTION OF SYMBOLS
Wear eye, ear & breathing
protection
Beats per minute
Double insulated
Warning
Regulatory Compliance Mark
(RCM)
V
Volts
Hz
W
Hertz
~
mm
bpm
/min
Alternating Current
Watts
Millimetre
Revolutions or reciprocations
per minute
Read Instruction Manual
Power tools that are no longer usable should not
be disposed of with household waste but in an
environmentally friendly way. Please recycle where
facilities exist. Check with your local council authority for
recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution
in the environment. Please recycle packaging where
facilities exist. Check with your local council authority for
recycling advice.
CARING FOR THE ENVIRONMENT
SPARE PARTS
Spare parts can be ordered from the Special Orders Desk at your
local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
Cleaning
1. We recommend that you clean the appliance immediately after
you use it.
2. Keep the safety devices free of dirt and dust as much as
possible. Wipe the equipment with a clean cloth.
3. Clean the appliance regularly with a damp cloth and some soft
soap. Do not use cleaning agents or solvents; these may be
aggressive to the plastic parts in the appliance. Ensure that no
water can get into the interior of the appliance.
Carbon Brushes
A small amount of sparking may be visible through the
housing vents. This is normal and does not indicate a
problem.
Excessive sparking visible through the housing air vents and/or
the tool failing to operate may indicate the carbon brushes have
worn out and need to be replaced. Discontinue use as soon as this
happens. They should be replaced prior to recommencing use of
the tool.
Carbon brushes are a wearing component and therefore not
covered under warranty. Continuing to use the tool when carbon
brushes need to be replaced may cause permanent damage to the
tool. Carbon brushes will wear out after many uses but when the
carbon brushes need to be replaced, take the tool to an electrician
or a power tool repairer for a quick and low cost replacement.
Always replace both carbon brushes at the same time.
Storage
Pull the mains plug out of the socket, switch off the tool and make
sure that it is secured in such a way that it cannot be started up
again by any unauthorised person.
Store the tool in a dry location which is not accessible to
unauthorised persons.
Supply Cords
If replacement of the supply cord is necessary, this has to be done
by a certified electrician in order to avoid a safety hazard.
Note:
Ozito Industries will not be responsible for any damage or
injuries caused by the repair of the tool by an unauthorised person
or by mishandling of the tool.
WARNING!
BEFORE CLEANING THE APPLIANCE OR
CARRYING OUT ANY MAINTENANCE PROCEDURE,
MAKE SURE THAT IT IS DISCONNECTED FROM THE
POWER SUPPLY TO PREVENT ACCIDENTAL STARTING.
