To obtain the desired cutting height, the front and rear axles are
repositioned on the underside of the mower housing.
1. Press and hold the lock-off
button.
To prevent accidental start up of the motor the mower is fitted with a
dual action switch
WARNING!:
DISCONNECT THE MOWER FROM
THE POWER SUPPLY AND ENSURE THE BLADE
HAS STOPPED COASTING BEFORE ADJUSTING THE
HEIGHT.
3. ADJUSTMENTS
Cutting Height Adjustment
4. SWITCHING ON/OFF
CAUTION:
TO REDUCE THE RISK OF ELECTRICAL SHOCK,
WE RECOMMEND THE USE OF A RESIDUAL CURRENT
DEVICE (RATED 30mA OR LESS).
1
2. Pull the Start/stop lever towards
the handle and hold in position,
the motor will now start.
3. Release the lock-off button
4. Release the Start/stop lever to
stop the mower.
1. Place the mower on its side.
2. Pull the wheel axle towards
the front of the mower.
3. Locate the wheel axle into
the desired cutting height
adjustment position.
2
Note:
Make sure that front, back,
left & right wheels are located in
the same cutting height adjustment
position.
1
2
3
Cutting Height Positions
1 - 30mm (lowest).
2 - 50mm.
3 - 70mm (highest).
WARNING!
THE BLADE WILL STOP A FEW
SECONDS AFTER THE SWITCH HAS BEEN
RELEASED. BE AWARE OF THE NECESSARY TIME IT
TAKES FOR THE BLADE TO STOP. DO NOT ATTEMPT
TO STOP THE BLADE.
Overload Protection
The mower has an internal cut off switch which will stop the operation
of the motor temporarily if too high in temperature. This cut off switch
will suddenly stop the motor from operating should the motor become
too hot during the operation of the mower.
First disconnect the mower from the power supply and inspect blade
for any obstructions.
A wait of 10 minutes in cooling time, or longer depending on ambient
temperature and the operation being performed, before switching On
the mower and resuming normal operation.
OPERATION
