OPERATION
To obtain the desired cutting height, the front and rear axles are
repositioned on the underside of the mower housing.
1. Secure the power cord from the
switch housing to the mower using
cable ties (supplied).
2. To assemble the grass catcher
align the two halves and push
them together, one side at a
time. Ensure the two halves click
together around the entire middle
section.
1. Assemble the grass catcher
handle onto the opening
on the top half of the grass
catcher. The handle will click
into position when aligned
and fitted correctly.
WARNING!:
WHEN ASSEMBLING THE GRASS
CATCHER BACK TO THE MOWER AFTER
EMPTYING, ALWAYS ENSURE THERE IS NO BUILD
UP OF GRASS IN THE GRASS CHUTE. IF NEEDING TO
CLEAR THE GRASS, ALWAYS ENSURE THE MOWER
IS DISCONNECTED FROM THE POWER SUPPLY
PRIOR TO CLEARING. A BUILD UP OF GRASS IN THE
GRASS CHUTE MAY PREVENT GRASS FROM MOVING
INTO THE GRASS CATCHER EFFECTIVELY.
WARNING!:
DISCONNECT THE MOWER FROM
THE POWER SUPPLY AND ENSURE THE BLADE
HAS STOPPED COASTING BEFORE ADJUSTING THE
HEIGHT.
Securing the Power Cord to the Handles
Assembling the Grass Catcher
“CLICK”
“CLICK”
“CLICK”
Fitting and Removing Grass Catcher
2. PREPARATION
Cutting Height Adjustment
3. To empty the grass catcher, lift
the catcher flap with one hand
then lift the grass catcher with
the other hand up off the two
raised housing clips.
The catcher must be attached to the two raised hooks on the mower.
1. Lift up the catcher flap with one
hand and guide the catcher over
the two hooks on the mower
housing.
2. Lower the grass catcher in place
and lower the catcher flap. The
catcher flap is held against the
gass catcher by a spring
1. Place the mower on its side.
2. Pull the wheel axle towards
the front of the mower.
3. Locate the wheel axle into
the desired cutting height
adjustment position.
HOOK
Using the Cord Retainer
1. Make a loop with the extension
lead (socket end of lead)
through the loop and secure
over the hook.
2. Once fitted, connect the lawn
mower power plug into the
extension lead socket.
Note:
Make sure that front, back,
left & right wheels are located in
the same cutting height adjustment
position.
1
2
3
Cutting Height Positions
1 - 30mm (lowest).
2 - 50mm.
3 - 70mm (highest).
The cord retainer prevents the extension lead (not included) from
being disconnected during use. Only use Heavy Duty extension lead
suitable for outdoor use with electric garden tools, no longer than 25
meters.
