MAINTENANCE
•
If the adjustment ring is aligned with the drill setting the torque clutch will
be disabled.
•
Keep the ventilation slots of the tool clean at all times. If possible prevent foreign
matter from entering the vents.
•
After each use, blow air through the tool to ensure it is free from all dust particles
that may build up. Build up of dust particles may cause the tool to overheat and fail.
•
If the enclosure of the tool requires cleaning do not use solvents but a moist soft
cloth only. Never let any liquid get inside the tool; never immerse any part of the
tool into a liquid.
•
When the carbon brushes wear out the tool will spark and/or stop. The brushes are
a wearing component of the tool and should be replaced prior to the carbon
wearing out fully. Brushes will wear out after many uses but before they do take
the tool to a power tool repairer for quick and low cost replacement. Always
replace both brushes at the same time.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by the
repair of the tool by an unauthorised person or by mishandling of the tool.
9
