INTRODUCTION
ELECTRICAL SAFETY
4
The Ozito 3 in 1 Blower, Vacuum & Mulcher provides a complete solution to your
garden maintenance needs.
It is ideal for blowing leaves, grass clippings and other debris from courtyards,
driveways, decks and footpaths. The variable speed ensures greater control when
blowing different material from lightweight grass clippings to wet leaves.
The single action lever allows quick change over from blow to vacuum mode, it is suitable
for vacuuming leaves, grass clippings and garden debris.
Featuring a 10:1 mulching ratio it will reduce large piles of waste into easily manageable
mulch. A metal mulching blade ensures greater durability and delivers the strength to
mulch hard garden waste such as twigs and nuts.
With a large 45 litre collection bag the vacuum collects all of your material for easy
disposal or composting.
This product is intended for DIY use only.
Warning!
When using mains-powered equipment, basic safety precautions,
including the following, should always be followed to reduce risk of fire,
electric shock, personal injury and material damage.
Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for future reference.
The electric motor has been designed for 230V and 240V only. Always check that
the power supply corresponds to the voltage on the rating plate.
Note:
The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.
This tool is double insulated in accordance with AS/NZS 3100; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced by an electrician or a power
tool repairer in order to avoid a hazard.
Note:
Double insulation does not take the place of normal safety precautions when
operating this tool. The insulation system is for added protection against injury
resulting from a possible electrical insulation failure within the tool.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective.
When using an extension lead on a reel, always unwind the lead completely. Use of
an extension lead not suitable for the power input of the tool or which is damaged or
defective may result in a risk of fire and electric shock.
It is recommended that the extension lead is a maximum of 25m in length. Do Not
use multiple extension leads.
GENERAL SAFETY INSTRUCTIONS
BVP-2400 Manual.qxd 9/11/09 5:40 PM Page 4