ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
BAND SAW
KNOW YOUR PRODUCT
Before commencing any operations, refer to the Setup and
Adjustment Manual to make sure that the Band Saw has been
Assembled and Setup correctly.
SETUP & PREPARATION
WARNING!
TO PREVENT ACCIDENTAL STARTING,
ENSURE THE BAND SAW IS DISCONNECTED FROM THE
POWER SUPPLY BEFORE MAKING ANY ADJUSTMENTS
1. SETUP AND ADJUSTMENTS
1. Tensioning Knob
2. Upper Blade Pulley
3. Upper Door
4. ON/OFF Switch
5. Lower Door
6. Rip Fence
7. Rip Fence Locking Lever
8. Lower Blade Pulley
9. Upper Door Lock
10. Blade Guard Adjustment
11. Blade Guard
12. Upper Blade Guide
13. Saw Table
14. Stabiliser Bar
15. Lower Door Lock
16. Machine Base
0
I
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
0
0
10
0
20
0
30
0
40
0
45
0
17. Blade Guard Locking Knob
18. Blade
19. Table Tilt Locking Knob
20. Table Tilt Locking Lever
21. Pulley Tracking Adjustment Knob
22. Pulley Tracking Retaining Nut
23. Table Support Bolt
24. Push Stick
25. Hex Keys (3, 4, 5mm)
ACCESSORIES
21
22
23
24
25
17
18
19
20
Adjusting the Blade Guard
Rip Fence
2
Rotate the blade guard
adjustment to lower the blade
guide as close as possible
to the work piece to be cut.
The gap should be approx.
2-3mm between the material
and blade guide.
1
Release the rip fence lever
by pulling it upwards.
2
Move the rip fence along the
table, from either the right
or left side, and position as
required.
3
Push the lever down to
secure the rip fence. If the
clip does not give enough
hold, turn it clockwise several
times and then press the
lever down.
4
You must always ensure that
the rip fence is positioned
parallel to the blade.
0
I
0
I
0
I
1 Loosen the blade
guard locking knob at
the back of the unit.
3
Secure in position by
tightening the blade
guard locking knob.
Note:
Check the setting
before each cut and re-
adjust if necessary.
0
0
10
0
20
0
30
0
40
0
45
0
0
0
10
0
20
0
30
0
40
0
45
0