2. GRINDING DISC
3. SWITCHING ON & OFF
OPERATION
1 Slide and hold the lock-off
slide switch to the right.
2 Push the on/off switch into the
on position to start the grinder.
3 To stop the grinder, push the
on/off switch backward into the
off position.
1 Depress and hold the spindle
lock button.
The angle grinder is fitted with a lock-off slide switch to avoid accidental
start up.
3 Use the pin spanner to loosen
the outer flange.
5 Screw the outer flange onto
the spindle.
Note:
The flat side of the flange
locates against the disc.
Inspect the grinding disc before fitment to ensure it is not cracked or
deformed. The grinding disc is suitable for grinding tasks only. Only use
grinding discs with a diameter of 100mm.
2 Rotate the spindle to locate
the lock position.
4 Insert the disc with the label
facing up.
6 Depress and hold the spindle
lock button. Firmly tighten
the outer flange with the pin
spanner.
CAUTION:
REGULARLY CHECK THAT THE
OUTER FLANGE HAS NOT BECOME LOOSE
DURING OPERATION.
WARNING:
THE TOOL IS RECOMMENDED FOR
USE WITH A RESIDUAL CURRENT DEVICE WITH A
RATED RESIDUAL CURRENT OF 30MA OR LESS.
