TROUBLESHOOTING
MAINTENANCE
If the air chisel fails to work effectively, perform the following
checks:
•
Check the air regulator is not fully tightened. Try selecting a higher
||
setting.
•
Check the air inlet is free of any dirt or blockages.
• Ensure the chisel is lubricated properly.
• Check that the pressure on the air compressor is within its
||
working range. If not, let the compressor rest to
||
re-pressurise / refer to the compressor instruction manual.
Note: This tool is rated at 90psi. Ensure your compressor is set no higher than 90psi.
• Keep the ventilation vents of the chisel clean at all times, if
possible, prevent foreign matter from entering the vents.
• If the enclosure of the chisel requires cleaning, do not use
solvents but a moist soft cloth only. Never let any liquid get inside
the chisel; never immerse any part of the chisel into a liquid.
•
Oil the chisel after each use.
CONNECTING TO COMPRESSOR
OPERATION
ATTACHING TOOLS
3. Screw the male nitto fitting
clockwise into the female end
of the air inlet
.
4. Pull back the sleeve on hose
fitting, insert male end & release
sleeve on hose fitting.
1. Remove black plastic cap
from air inlet.
2. Wrap the threaded male
end with teflon tape in a
clockwise direction.
2. To turn the chisel on, squeeze
the on/off trigger. To turn off,
release the on/off trigger.
1. Select the desired tool attachment
and lock into place using the quick
change spring.
2. Slide the attachment into the
hole while holding the quick change
spring back.
1. Screw the quick change spring onto
the housing.
3. To release the attachment pull
back the spring and then remove.
3. To restrict the air flow turn the
regulator valve to a lower setting.
WARNING! Before attaching or removing any accessories, be sure to disconnect the air chisel from the air supply.
Alternatively, you can place the accessory into the housing and then screw in the quick change spring.